contact pressure sentence in Hindi
Sentences
Mobile
- However, a load on an infinitely small point would cause infinitely high contact pressure.
- Cast trucks are also prone to warping slightly, causing uneven contact pressure on the wheels.
- A high contact pressure assures a low-ohmic contact or alleviates dielectric charging induced beam stiction.
- Excessive contact pressure can lead to a typical bearing failure such as a plastic deformation similar to peening.
- This material flow is critical when defining the contact pressure, energy density, and developed temperature during sliding.
- He found that increasing the contact pressure and adding an electrical bias to the detector improved its performance greatly.
- It's clear, given these prerequisites, that contact pressure and developed temperature is highly dependent on the lumps geometry.
- It can be applied to the actual contact as well, because the contact pressure is sufficient to penetrate the grease film.
- The model is therefore accurate at high loads, when the hydrodynamic pressure tends to be close to the Hertz contact pressure.
- It also enables a better length compensation as well as even and low contact pressures, which avoids damages on the coaxial cable.
- Differences in hind limb and fore limb surface area, and therefore contact pressure with the substrate, may sometimes lead to only the forefeet trackways being preserved.
- Furthermore, the response to the impact of a piece of feather ( 20 mg, ~ 0.4 Pa in contact pressure ) can be detected.
- These grains, commonly called grit, have rough edges, often terminating in points which will decrease the surface area in contact and increase the localised contact pressure.
- The Scotch yoke is not used in most internal combustion engines because of the rapid wear of the slot in the yoke caused by sliding friction and high contact pressures.
- Since the contact pressure is the most important factor, most studies, correlations and mathematical models for measurement of contact conductance are done as a function of this factor.
- The maximum sliding speed was 4 m / s and the geometrical contact pressure was limited to 5 MPa . ( These operating conditions were related to railway wagon journal bearings .)
- In order to achieve that, an adjustment mechanism is necessary, which enables the technicians to adjust the contact pressure of each individual gliding element in a controllable and secure way.
- The geometry and the nominal sliding velocity of the lump defines how the flowing material will be transported and accelerated around the lump which is critical to define contact pressure and developed temperature during sliding.
- In this way it is possible to apply various levels of contact pressure among the different gliding pads and therefore to ensure that each gliding component of the yaw bearing arrangement is performing as anticipated.
- The contacts in the plug are simple cylinders ( sleeves ), while the pin contacts in the receptacle have the spring arrangement to hold contact pressure, the reverse of the IEC 60309 type connectors.
- More Sentences: 1 2
contact pressure sentences in Hindi. What are the example sentences for contact pressure? contact pressure English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.